Swea Grid Tie Wind Turbine starter kit...... The Swea Grid Tie Inverter provides a safe, efficient, cost effective, battery free solution to hook your wind turbine or wind generator to you homes power grid. This starter kit will get your small wind turbine up to a maximum of 250 watts hooked to the grid. Expandable in 250 watt increments to 1000 watts.

This Swea Grid Tie Starter kit is for use with wind turbines.....for solar only applications see the grid tie extensions.

• 1-3 phase rectifier

• 1-AP box for stacking and safety shut off of wind turbine

• 1-Dump load to slow wind turbine down in high wind and  power diversion in case of grid failure
• 1- 250 watt grid tie

SWEA Europe has developed a grid tie inverter system for 250 watt, 500
watt, 750 watt, and 1 KW wind turbines.  This same system can also be used
with solar panels, with each module being ideal for 2 x 130 watt solar
panels. The inverters can convert 20 to 54 volt DC directly to AC and plug
right into any electrical outlet.

The inverter connects your wind turbine or solar panels directly to the
110/220 Volt Grid.  The inverter can be used for both 50 or 60 HZ.  The
power your renewable system generates will slow down your power meter
during peak energy usage and can even spin the meter backwards in areas
that allow net metering.

Simply install a wind turbine or solar panels, connect to the inverter,
and plug the inverter into any wall outlet to generate your own electricity.  Up
to 4 inverters can be stacked parallel with the AP-Box for a maximum 1KW
system.  This inverter system is perfect for the AIR-X wind turbines.


when ordering specify wind turbine type  if you wish to have your unit programmed for highest efficiency .......I highly recommend this

Since this unit starts feeding the grid at 20 volts programmed at the lowest v start not recommended   for use with 12 volt wind turbines that are regulated to voltages below 20 volts